Deutsch
Foren
Mitglieder
pbnj
Aktivität
 
Benachrichtigungen
Alles löschen
pbnj
pbnj
Gruppe: Registriert
Beigetreten: 2016/05/15
Trusted Member
3
Profil Aktivität
The unit work really well right out of the box. The only thi...

Im Forum Others (Archive)

 Vor 10 years
In simplify3d would this be the setting under extruder /Ooze...

Im Forum Others (Archive)

 Vor 10 years
I have two that have been working 24/7 with only very minor ...

Im Forum Others (Archive)

 Vor 10 years
thanks

Im Forum Others (Archive)

 Vor 10 years
LIST OF G CODES

Im Forum Others (Archive)

 Vor 10 years
What is causing the blockage. Keep my finger crossed I have ...

Im Forum Others (Archive)

 Vor 10 years
Assuming that you have good layers then bad layers, I have s...

Im Forum Others (Archive)

 Vor 10 years
What exactly is the problem?

Im Forum Others (Archive)

 Vor 10 years
Lost of bed calibration

Im Forum Others (Archive)

 Vor 10 years
Also check and make sure that your filament drive gear, the ...

Im Forum Others (Archive)

 Vor 10 years
I have notice that the more I print the marks seem to be les...

Im Forum Others (Archive)

 Vor 10 years
.8mm nozzle tips with PLA

Im Forum Others (Archive)

 Vor 10 years
#1 work on a surface where if you drop a screw you can find ...

Im Forum Others (Archive)

 Vor 10 years
What slicer are you using. What is the manufactor of the PLA...

Im Forum Others (Archive)

 Vor 10 years
I too have the same driver and firmware that you are running...

Im Forum Others (Archive)

 Vor 10 years
Outside finish

Im Forum Others (Archive)

 Vor 10 years
Did not see this. Spoke with customer service and they advis...

Im Forum Hardware, firmware and software help

 Vor 10 years
Just gat my second MK2 (Factory assembled) and there were n...

Im Forum Others (Archive)

 Vor 10 years
ULTEM PEI bed film replacement

Im Forum Hardware, firmware and software help

 Vor 10 years
The correct software works wonders. Fixed Than ks all.

Im Forum Others (Archive)

 Vor 10 years
Seite 4 / 5
Teilen: