English
Forums
Members
pbnj
Activity
 
Notifications
Clear all
pbnj
pbnj
Group: Registered
Joined: 2016/05/15
Trusted Member
3
Profile Activity
The unit work really well right out of the box. The only thi...

In forum Others (Archive)

 10 years ago
In simplify3d would this be the setting under extruder /Ooze...

In forum Others (Archive)

 10 years ago
I have two that have been working 24/7 with only very minor ...

In forum Others (Archive)

 10 years ago
thanks

In forum Others (Archive)

 10 years ago
LIST OF G CODES

In forum Others (Archive)

 10 years ago
What is causing the blockage. Keep my finger crossed I have ...

In forum Others (Archive)

 10 years ago
Assuming that you have good layers then bad layers, I have s...

In forum Others (Archive)

 10 years ago
What exactly is the problem?

In forum Others (Archive)

 10 years ago
Lost of bed calibration

In forum Others (Archive)

 10 years ago
Also check and make sure that your filament drive gear, the ...

In forum Others (Archive)

 10 years ago
I have notice that the more I print the marks seem to be les...

In forum Others (Archive)

 10 years ago
.8mm nozzle tips with PLA

In forum Others (Archive)

 10 years ago
#1 work on a surface where if you drop a screw you can find ...

In forum Others (Archive)

 10 years ago
What slicer are you using. What is the manufactor of the PLA...

In forum Others (Archive)

 10 years ago
I too have the same driver and firmware that you are running...

In forum Others (Archive)

 10 years ago
Outside finish

In forum Others (Archive)

 10 years ago
Did not see this. Spoke with customer service and they advis...

In forum Hardware, firmware and software help

 10 years ago
Just gat my second MK2 (Factory assembled) and there were n...

In forum Others (Archive)

 10 years ago
ULTEM PEI bed film replacement

In forum Hardware, firmware and software help

 10 years ago
The correct software works wonders. Fixed Than ks all.

In forum Others (Archive)

 10 years ago
Page 4 / 5
Share: