Polski
Fora
Członkowie
osrt
Aktywność
 
Notifications
Clear all
osrt
osrt
Grupa: Zarejestrowany
Dołączył: 2016/10/10
Active Member
1
Profil Aktywność
Also, for the life of me, I can't see any live help on Prusa...

In forum Prusa i3 kit (Archive)

 10 years temu
Finally, I disconnected the heatbed connector, put the bed t...

In forum Prusa i3 kit (Archive)

 10 years temu
What do you mean by "still getting short"? Heatbed itself (i...

In forum Prusa i3 kit (Archive)

 10 years temu
Took all 6 screw housings and the metal washers underneath t...

In forum Prusa i3 kit (Archive)

 10 years temu
that's the input voltage, have you checked the actual outpu...

In forum Prusa i3 kit (Archive)

 10 years temu
Just a thought - is the PSU set for the correct voltage? Pe...

In forum Prusa i3 kit (Archive)

 10 years temu
I am starting to think the issue here is due to the power su...

In forum Prusa i3 kit (Archive)

 10 years temu
Do not over do movement of motors by hand. It can damage the...

In forum Prusa i3 kit (Archive)

 10 years temu
I think the motors act as generators and it's generating eno...

In forum Prusa i3 kit (Archive)

 10 years temu
If you have an oscilloscope you can check the power and rest...

In forum Prusa i3 kit (Archive)

 10 years temu
I am pretty sure the LCD flashing and going back to the Info...

In forum Prusa i3 kit (Archive)

 10 years temu
Are you using .gcode files or are you using a slicer program...

In forum Prusa i3 kit (Archive)

 10 years temu
Just in case it's a bad flash of firmware, try run the firmw...

In forum Prusa i3 kit (Archive)

 10 years temu
Just a quick update: I was never quite happy with the nois...

In forum Prusa i3 kit (Archive)

 10 years temu
Print stops in second layer

In forum Prusa i3 kit (Archive)

 10 years temu
Share: