Čeština
Fóra
Uživatelé
osrt
Aktivita
 
Notifications
Clear all
osrt
osrt
Skupina: Registrovaný
Přidal se: 2016/10/10
Active Member
1
Profile Aktivita
Also, for the life of me, I can't see any live help on Prusa...

In forum Prusa i3 kit (Archive)

 před 10 years
Finally, I disconnected the heatbed connector, put the bed t...

In forum Prusa i3 kit (Archive)

 před 10 years
What do you mean by "still getting short"? Heatbed itself (i...

In forum Prusa i3 kit (Archive)

 před 10 years
Took all 6 screw housings and the metal washers underneath t...

In forum Prusa i3 kit (Archive)

 před 10 years
that's the input voltage, have you checked the actual outpu...

In forum Prusa i3 kit (Archive)

 před 10 years
Just a thought - is the PSU set for the correct voltage? Pe...

In forum Prusa i3 kit (Archive)

 před 10 years
I am starting to think the issue here is due to the power su...

In forum Prusa i3 kit (Archive)

 před 10 years
Do not over do movement of motors by hand. It can damage the...

In forum Prusa i3 kit (Archive)

 před 10 years
I think the motors act as generators and it's generating eno...

In forum Prusa i3 kit (Archive)

 před 10 years
If you have an oscilloscope you can check the power and rest...

In forum Prusa i3 kit (Archive)

 před 10 years
I am pretty sure the LCD flashing and going back to the Info...

In forum Prusa i3 kit (Archive)

 před 10 years
Are you using .gcode files or are you using a slicer program...

In forum Prusa i3 kit (Archive)

 před 10 years
Just in case it's a bad flash of firmware, try run the firmw...

In forum Prusa i3 kit (Archive)

 před 10 years
Just a quick update: I was never quite happy with the nois...

In forum Prusa i3 kit (Archive)

 před 10 years
Print stops in second layer

In forum Prusa i3 kit (Archive)

 před 10 years
Share: