Prusa3D Forum

Benachrichtigungen

Alles löschen

osrt

Gruppe: Registriert

Beigetreten: 2016/10/10

Active Member

	Also, for the life of me, I can't see any live help on Prusa... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Finally, I disconnected the heatbed connector, put the bed t... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	What do you mean by "still getting short"? Heatbed itself (i... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Took all 6 screw housings and the metal washers underneath t... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	that's the input voltage, have you checked the actual outpu... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Just a thought - is the PSU set for the correct voltage? Pe... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	I am starting to think the issue here is due to the power su... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Do not over do movement of motors by hand. It can damage the... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	I think the motors act as generators and it's generating eno... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	If you have an oscilloscope you can check the power and rest... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	I am pretty sure the LCD flashing and going back to the Info... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Are you using .gcode files or are you using a slicer program... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Just in case it's a bad flash of firmware, try run the firmw... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Just a quick update: I was never quite happy with the nois... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Print stops in second layer Im Forum Prusa i3 kit (Archive)	Vor 8 years

Forums-Statistiken

559 Foren

62.9 K Themen

442.9 K Beiträge

20 Online

67.7 K Mitglieder

Letzter Beitrag: PrusaConnect camera with raspberry pi + curl Unser neuestes Mitglied: pinklemonade Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen