Prusa3D Forum

Notifications

Clear all

ormandj

Groupe: Enregistré

A(ont) rejoint: 2017/09/25

Active Member

	But when I look at the Filament Settings tab, the "Extrusion... Dans le forum Others (Archive)	il y a 7 years
	Thank you for the update. This mirrors most of the settings ... Dans le forum Others (Archive)	il y a 7 years
	This happens with me when using pronterface. Never have this... Dans le forum Others (Archive)	il y a 7 years
	What settings/filament did you use? Curious what's modified ... Dans le forum Others (Archive)	il y a 7 years
	Why would you treat any move by any axis that wasn't intenti... Dans le forum Others (Archive)	il y a 7 years
	Benchy while printing looked better than before internally, ... Dans le forum Others (Archive)	il y a 7 years
	My sheet was covered in these prior to printing anything. It... Dans le forum Others (Archive)	il y a 7 years
	Updated everything (firmware/software), recalibrated, and no... Dans le forum Others (Archive)	il y a 7 years
	I've got feeler gauges which will work fine, just need to kn... Dans le forum Others (Archive)	il y a 7 years
	Phew! I am glad I am not the only one that noticed this! I w... Dans le forum Others (Archive)	il y a 7 years
	It actually sounds rough on mine post-update. I thought I mi... Dans le forum Others (Archive)	il y a 7 years
	Have the same problems on mine (including filament loading).... Dans le forum Others (Archive)	il y a 7 years
	I had this issue, like others, it was the pully on the motor... Dans le forum Others (Archive)	il y a 7 years
	Interesting, also on my frame it was the front right corner ... Dans le forum Others (Archive)	il y a 7 years
	I have the same issue as mentioned above with the front righ... Dans le forum Others (Archive)	il y a 7 years

Statistiques du forum

559 Forums

63.1 K Sujets

443.8 K Messages

23 En-ligne

68.1 K Membres

Le dernier des messages: MK4S PETG Warping Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé