Notifications
Clear all
ormandj
ormandj
Group: Registered
Joined: 2017/09/25
Eminent Member
2
So update on my saga. My old printer was returned, new one s...

In forum Hardware, firmware and software help

6 months ago
I have the same issue. Check to see if your door is shutting...

In forum Hardware, firmware and software help

7 months ago
For what it's worth, I have the same problem (covered in ano...

In forum Assembly and first prints troubleshooting

7 months ago
Correct, the X axis is what's actually being pulled out of a...

In forum Hardware, firmware and software help

7 months ago
That video shows calibrating the belt tension with the carri...

In forum Hardware, firmware and software help

7 months ago
I tried adjusting my belts using the newly added option in t...

In forum Hardware, firmware and software help

7 months ago
Quality was slightly improved on mine, it was more visible w...

In forum General discussion, announcements and releases

7 months ago
I just performed this, mine was significantly different than...

In forum General discussion, announcements and releases

7 months ago
But when I look at the Filament Settings tab, the "Extrusion...

In forum Others (Archive)

8 years ago
Thank you for the update. This mirrors most of the settings ...

In forum Others (Archive)

8 years ago
This happens with me when using pronterface. Never have this...

In forum Others (Archive)

8 years ago
What settings/filament did you use? Curious what's modified ...

In forum Others (Archive)

8 years ago
Why would you treat any move by any axis that wasn't intenti...

In forum Others (Archive)

8 years ago
Benchy while printing looked better than before internally, ...

In forum Others (Archive)

8 years ago
My sheet was covered in these prior to printing anything. It...

In forum Others (Archive)

8 years ago
Updated everything (firmware/software), recalibrated, and no...

In forum Others (Archive)

8 years ago
I've got feeler gauges which will work fine, just need to kn...

In forum Others (Archive)

8 years ago
Phew! I am glad I am not the only one that noticed this! I w...

In forum Others (Archive)

8 years ago
It actually sounds rough on mine post-update. I thought I mi...

In forum Others (Archive)

8 years ago
Have the same problems on mine (including filament loading)....

In forum Others (Archive)

8 years ago
Page 1 / 2
Share: