Activité
 
Notifications
Clear all
Onur
Onur
Groupe: Enregistré
A(ont) rejoint: 2020/02/21
Trusted Member
3
@cwbullet Yes, I've contacted support via chat several times...

Dans le forum Hardware, firmware and software help

il y a 4 years
@clarmrrsn I've widened the gap of the motor pulley as you s...

Dans le forum Hardware, firmware and software help

il y a 4 years
@tim-2 Hi,Thank you very much for the tips, really appreciat...

Dans le forum Hardware, firmware and software help

il y a 4 years
@ben_r_ Hi, Sorry for the quite late reply but I couldn't fi...

Dans le forum Hardware, firmware and software help

il y a 4 years
@bobstro I've replaced the nozzle with a new one as well las...

Dans le forum PrusaSlicer

il y a 4 years
@bobstro I've already tried decreasing the print temp. That ...

Dans le forum PrusaSlicer

il y a 4 years
@bobstro I thought the same thing about the moistured filame...

Dans le forum PrusaSlicer

il y a 4 years
Hi,I've been using Bobstro's support settings for a long tim...

Dans le forum PrusaSlicer

il y a 4 years
Hi,I've been using bob's support settings for a long time. A...

Dans le forum PrusaSlicer

il y a 4 years
@bobstro I see. Thanks for the suggestion. Oh, I misspoken t...

Dans le forum Hardware, firmware and software help

il y a 4 years
@bobstro Out of curiosity, do you use stock fan design or ch...

Dans le forum Hardware, firmware and software help

il y a 4 years
@bobstro Thank you for the detailed experiment. I know that ...

Dans le forum Hardware, firmware and software help

il y a 4 years
@bobstro Thanks for the help. Really appreciate it! I left t...

Dans le forum Hardware, firmware and software help

il y a 4 years
@jsw Oh, i'm sorry to hear that. That's because the model fi...

Dans le forum Hardware, firmware and software help

il y a 4 years
@bobstro I didn't mean turn this into a stupid pissing conte...

Dans le forum Hardware, firmware and software help

il y a 4 years
@jsw I'm sorry I forgot to say that both prints were sliced ...

Dans le forum Hardware, firmware and software help

il y a 4 years
@neophyl I get you but I still think stock mk3s fan should w...

Dans le forum Hardware, firmware and software help

il y a 4 years
My Ender 3 Pro is better on overhangs than my MK3S?

Dans le forum Hardware, firmware and software help

il y a 4 years
I'm having the same issue. I get several y axis crashes ever...

Dans le forum Hardware, firmware and software help

il y a 4 years
I decided to look idler pulley by removing the x axis becaus...

Dans le forum Hardware, firmware and software help

il y a 4 years
Page 1 / 3
Partager :