|
Time remaining to filament colour change? In forum Hardware, firmware and software help |
1 year ago |
|
Well, it’s reassuring to see others have experienced the sam... In forum Hardware, firmware and software help |
1 year ago |
|
Control Panel Display During Printing In forum Hardware, firmware and software help |
2 years ago |
|
Thank you so much. Never thought of looking on the back. In forum Hardware, firmware and software help |
2 years ago |
|
Ok. Thank you. In forum Hardware, firmware and software help |
2 years ago |
|
At the time of taking this picture it looks like one was ill... In forum Hardware, firmware and software help |
2 years ago |
|
My apologies. You're right. It's not 2FA. But it's still a P... In forum Introduction & Instructions |
2 years ago |
|
I should have made myself clearer. I'm not talking about Pru... In forum Introduction & Instructions |
2 years ago |
|
I'm with DoctorG on this one. Considering this is connecting... In forum Introduction & Instructions |
2 years ago |
|
Nextruder LEDs In forum Hardware, firmware and software help |
2 years ago |
|
Very good question. I'm using 2.4.2 and encountering the sam... In forum PrusaSlicer |
3 years ago |
