Prusa3D Forum

Notifications

Clear all

nosmarb

Skupina: Registrovaný

Přidal se: 2022/06/05

Active Member

	Time remaining to filament colour change? In forum Hardware, firmware and software help	před 2 years
	Well, it’s reassuring to see others have experienced the sam... In forum Hardware, firmware and software help	před 2 years
	Control Panel Display During Printing In forum Hardware, firmware and software help	před 2 years
	Thank you so much. Never thought of looking on the back. In forum Hardware, firmware and software help	před 2 years
	Ok. Thank you. In forum Hardware, firmware and software help	před 2 years
	At the time of taking this picture it looks like one was ill... In forum Hardware, firmware and software help	před 2 years
	My apologies. You're right. It's not 2FA. But it's still a P... In forum Introduction & Instructions	před 2 years
	I should have made myself clearer. I'm not talking about Pru... In forum Introduction & Instructions	před 2 years
	I'm with DoctorG on this one. Considering this is connecting... In forum Introduction & Instructions	před 2 years
	Nextruder LEDs In forum Hardware, firmware and software help	před 2 years
	Very good question. I'm using 2.4.2 and encountering the sam... In forum PrusaSlicer	před 3 years

Fórum Statistiky

585 Fóra

68.2 K Témata

477.9 K Příspěvky

9 Online

75.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed