Prusa3D Forum

Notifications

Clear all

nosmarb

Groupe: Enregistré

A(ont) rejoint: 2022/06/05

Active Member

	Time remaining to filament colour change? Dans le forum Hardware, firmware and software help	il y a 2 years
	Well, it’s reassuring to see others have experienced the sam... Dans le forum Hardware, firmware and software help	il y a 2 years
	Control Panel Display During Printing Dans le forum Hardware, firmware and software help	il y a 2 years
	Thank you so much. Never thought of looking on the back. Dans le forum Hardware, firmware and software help	il y a 2 years
	Ok. Thank you. Dans le forum Hardware, firmware and software help	il y a 2 years
	At the time of taking this picture it looks like one was ill... Dans le forum Hardware, firmware and software help	il y a 2 years
	My apologies. You're right. It's not 2FA. But it's still a P... Dans le forum Introduction & Instructions	il y a 2 years
	I should have made myself clearer. I'm not talking about Pru... Dans le forum Introduction & Instructions	il y a 2 years
	I'm with DoctorG on this one. Considering this is connecting... Dans le forum Introduction & Instructions	il y a 2 years
	Nextruder LEDs Dans le forum Hardware, firmware and software help	il y a 2 years
	Very good question. I'm using 2.4.2 and encountering the sam... Dans le forum PrusaSlicer	il y a 3 years

Statistiques du forum

585 Forums

68.2 K Sujets

477.9 K Messages

15 En-ligne

76 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé