Prusa3D Forum

Notifications

Clear all

navillus5

Groupe: Enregistré

A(ont) rejoint: 2019/10/04

Active Member

	PrusaSlicer output filenames for STL vs. 3MF Dans le forum General discussion, announcements and releases	il y a 3 years
	MK3s - shifting and separating layers Dans le forum How do I print this? (Printing help)	il y a 4 years
	So I've solved the issue. I followed this set of steps and i... Dans le forum Hardware, firmware and software help	il y a 4 years
	@fuchsr Thanks again for your response, but I would really l... Dans le forum Hardware, firmware and software help	il y a 4 years
	Thanks for the replies... I usually had the MINI setup to pr... Dans le forum Hardware, firmware and software help	il y a 4 years
	Yes. I also adjusted the tensioning screw. When I did this I... Dans le forum Hardware, firmware and software help	il y a 4 years
	Began using non-Prusament filaments and now I have all sorts... Dans le forum Hardware, firmware and software help	il y a 4 years
	Hi Joan - I wanted to get back to you with thanks a some pic... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Hi Joan - Wow - many thanks for taking the time to actually ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@joantabb Hi Joan - Thanks for the reply. This is a link to ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Printing 3D plane - 1 layer walls with 0 bottom later and 0 ... Dans le forum How do I print this? (Printing help)	il y a 4 years

Statistiques du forum

565 Forums

64.2 K Sujets

449.8 K Messages

21 En-ligne

70.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé