Prusa3D Forum

Avisos

Vaciar todo

navillus5

Grupo: Registrado

Registrado: 2019/10/04

Active Member

	PrusaSlicer output filenames for STL vs. 3MF En el foro General discussion, announcements and releases	hace 3 years
	MK3s - shifting and separating layers En el foro How do I print this? (Printing help)	hace 4 years
	So I've solved the issue. I followed this set of steps and i... En el foro Hardware, firmware and software help	hace 4 years
	@fuchsr Thanks again for your response, but I would really l... En el foro Hardware, firmware and software help	hace 4 years
	Thanks for the replies... I usually had the MINI setup to pr... En el foro Hardware, firmware and software help	hace 4 years
	Yes. I also adjusted the tensioning screw. When I did this I... En el foro Hardware, firmware and software help	hace 4 years
	Began using non-Prusament filaments and now I have all sorts... En el foro Hardware, firmware and software help	hace 4 years
	Hi Joan - I wanted to get back to you with thanks a some pic... En el foro How do I print this? (Printing help)	hace 4 years
	Hi Joan - Wow - many thanks for taking the time to actually ... En el foro How do I print this? (Printing help)	hace 4 years
	@joantabb Hi Joan - Thanks for the reply. This is a link to ... En el foro How do I print this? (Printing help)	hace 4 years
	Printing 3D plane - 1 layer walls with 0 bottom later and 0 ... En el foro How do I print this? (Printing help)	hace 4 years

Estadísticas del Foro

565 Foros

64.2 K Temas

449.8 K Respuestas

19 En línea

70.5 K Miembros

Iconos del foro: El foro no contiene publicaciones sin leer El foro contiene publicaciones sin leer

Iconos de los Temas: No respondidos Respondido Activo Popular Fijo No aprobados Resuelto Privado Cerrado