|
The statue model was floating in the air for some reason. Lo... En el foro How do I print this? (Printing help) |
hace 2 years |
|
Prusamen PLA Mystic Brown severe under extrusion - but suppo... En el foro How do I print this? (Printing help) |
hace 2 years |
|
Thank you, I thought I went crazy. I tried this so many time... En el foro Hardware, firmware and software help |
hace 2 years |
|
Sorry - I wrote this post from memory, there is no 3.12.3 fi... En el foro Hardware, firmware and software help |
hace 2 years |
|
The printer works again after I downgraded the firmware to v... En el foro Hardware, firmware and software help |
hace 2 years |
|
So it seems like it is a software bug in 3.13.0, could someb... En el foro Hardware, firmware and software help |
hace 2 years |
|
I did:Before:After (it's about 0.5 mm lower): It didn't help... En el foro Hardware, firmware and software help |
hace 2 years |
|
They are not, because the fact that going from firmware 3.13... En el foro Hardware, firmware and software help |
hace 2 years |
|
I bought it about two years ago and assembled it myself. En el foro Hardware, firmware and software help |
hace 2 years |
|
Unable to finish thermal model calibration En el foro Hardware, firmware and software help |
hace 2 years |
|
Don't know why, but embedded video did not show up:/p> En el foro Hardware, firmware and software help |
hace 2 years |
|
XYZ calibration error En el foro Hardware, firmware and software help |
hace 2 years |
|
I replaced formerly mentioned parts. As it turned out, the h... En el foro Hardware, firmware and software help |
hace 2 years |
|
It is PLA, as per my knowledge it can suck up moisture as we... En el foro Hardware, firmware and software help |
hace 2 years |
|
I've upgraded the firmware to the latest version. It did th... En el foro Hardware, firmware and software help |
hace 2 years |
|
Hotend randomly won't stop heating - a lot of smoke En el foro Hardware, firmware and software help |
hace 2 years |
