|
The statue model was floating in the air for some reason. Lo... In forum How do I print this? (Printing help) |
před 11 months |
|
Prusamen PLA Mystic Brown severe under extrusion - but suppo... In forum How do I print this? (Printing help) |
před 11 months |
|
Thank you, I thought I went crazy. I tried this so many time... In forum Hardware, firmware and software help |
před 1 year |
|
Sorry - I wrote this post from memory, there is no 3.12.3 fi... In forum Hardware, firmware and software help |
před 1 year |
|
The printer works again after I downgraded the firmware to v... In forum Hardware, firmware and software help |
před 1 year |
|
So it seems like it is a software bug in 3.13.0, could someb... In forum Hardware, firmware and software help |
před 1 year |
|
I did:Before:After (it's about 0.5 mm lower): It didn't help... In forum Hardware, firmware and software help |
před 1 year |
|
They are not, because the fact that going from firmware 3.13... In forum Hardware, firmware and software help |
před 1 year |
|
I bought it about two years ago and assembled it myself. In forum Hardware, firmware and software help |
před 1 year |
|
Unable to finish thermal model calibration In forum Hardware, firmware and software help |
před 1 year |
|
Don't know why, but embedded video did not show up:/p> In forum Hardware, firmware and software help |
před 1 year |
|
XYZ calibration error In forum Hardware, firmware and software help |
před 1 year |
|
I replaced formerly mentioned parts. As it turned out, the h... In forum Hardware, firmware and software help |
před 1 year |
|
It is PLA, as per my knowledge it can suck up moisture as we... In forum Hardware, firmware and software help |
před 1 year |
|
I've upgraded the firmware to the latest version. It did th... In forum Hardware, firmware and software help |
před 1 year |
|
Hotend randomly won't stop heating - a lot of smoke In forum Hardware, firmware and software help |
před 1 year |
