Avisos
Vaciar todo
motocoder
Grupo: Registrado
Registrado: 2017/12/08
Trusted Member
3
|
Ok I have the same issue and this linearization helps me. So... En el foro Hardware, firmware and software help |
hace 7 years | |
|
Do you try this?
Yeah, this is not the same thing. En el foro Hardware, firmware and software help |
hace 7 years | |
|
Strange surface pattern since MK3 R3 upgrade En el foro Hardware, firmware and software help |
hace 7 years | |
| I really like the interpolation change and the addition of p... | hace 7 years | |
| The plug-in is not firmware dependent, although with newer f... | hace 7 years | |
|
Don't buy the E3D titanium heat break En el foro Hardware, firmware and software help |
hace 7 years | |
| Excellent info, thanks! As an aside, every 3D Printer I hav... | hace 7 years | |
| I usually completely loosen the screws and open the idler do... | hace 7 years | |
| So the process that I am using is: before a print, check the... | hace 7 years | |
| Your code says to wait until the PINDA is >35C. Is the P... | hace 7 years | |
| Care to share your startup gcode for both slicers? Sure, h... | hace 7 years |
Página 1 / 5
Siguiente