Prusa3D Forum

Notifications

Clear all

mirza.d

Groupe: Enregistré

A(ont) rejoint: 2016/08/07

Active Member

	Thanks for the tip, that did the trick. Removing that side ... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Filament is stuck I think? What to do? Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	That did the trick, once I got the live Z layer adjusted the... Dans le forum Assembly and first prints troubleshooting	il y a 8 years
	That is good to know, I was setting it to 0.300mm and not -0... Dans le forum Assembly and first prints troubleshooting	il y a 8 years
	I will try the live Z calibrate tool again when I start the ... Dans le forum Assembly and first prints troubleshooting	il y a 8 years
	Still having the same issue, my PLA prints do not stick at a... Dans le forum Assembly and first prints troubleshooting	il y a 8 years
	Upgraded to latest firmware this evening and went through th... Dans le forum Assembly and first prints troubleshooting	il y a 8 years
	Thanks for the tips, i will try the Live Adjust Z for 0.100-... Dans le forum Assembly and first prints troubleshooting	il y a 8 years
	MK2 Kit assembled, first print is warping 🙁 what to do? Dans le forum Assembly and first prints troubleshooting	il y a 8 years

Statistiques du forum

559 Forums

63.1 K Sujets

443.9 K Messages

22 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé