Notifications
Clear all
mirza.d
Skupina: Registrovaný
Přidal se: 2016/08/07
Active Member
1
|
Thanks for the tip, that did the trick. Removing that side ... In forum Prusa i3 kit (Archive) |
před 10 years | |
|
Filament is stuck I think? What to do? In forum Prusa i3 kit (Archive) |
před 10 years | |
| That did the trick, once I got the live Z layer adjusted the... | před 10 years | |
| That is good to know, I was setting it to 0.300mm and not -0... | před 10 years | |
| I will try the live Z calibrate tool again when I start the ... | před 10 years | |
| Still having the same issue, my PLA prints do not stick at a... | před 10 years | |
| Upgraded to latest firmware this evening and went through th... | před 10 years | |
| Thanks for the tips, i will try the Live Adjust Z for 0.100-... | před 10 years | |
| MK2 Kit assembled, first print is warping 🙁 what to do? | před 10 years |