Prusa3D Forum

Benachrichtigungen

Alles löschen

mirza.d

Gruppe: Registriert

Beigetreten: 2016/08/07

Active Member

	Thanks for the tip, that did the trick. Removing that side ... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Filament is stuck I think? What to do? Im Forum Prusa i3 kit (Archive)	Vor 8 years
	That did the trick, once I got the live Z layer adjusted the... Im Forum Assembly and first prints troubleshooting	Vor 8 years
	That is good to know, I was setting it to 0.300mm and not -0... Im Forum Assembly and first prints troubleshooting	Vor 8 years
	I will try the live Z calibrate tool again when I start the ... Im Forum Assembly and first prints troubleshooting	Vor 8 years
	Still having the same issue, my PLA prints do not stick at a... Im Forum Assembly and first prints troubleshooting	Vor 8 years
	Upgraded to latest firmware this evening and went through th... Im Forum Assembly and first prints troubleshooting	Vor 8 years
	Thanks for the tips, i will try the Live Adjust Z for 0.100-... Im Forum Assembly and first prints troubleshooting	Vor 8 years
	MK2 Kit assembled, first print is warping 🙁 what to do? Im Forum Assembly and first prints troubleshooting	Vor 8 years

Forums-Statistiken

566 Foren

63.2 K Themen

444.2 K Beiträge

21 Online

68.1 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen