Prusa3D Forum

Notifications

Clear all

MintPrint

Grupa: Zarejestrowany

Dołączył: 2018/10/26

Active Member

	I have figured out the problem, kind of. I have 2 MK3S, and ... In forum Hardware, firmware and software help	4 years temu
	Thank you. There's not super noticeable print artifacts, but... In forum Hardware, firmware and software help	4 years temu
	@martys I removed the belt completely then turned the motor ... In forum Hardware, firmware and software help	4 years temu
	Thank you. I'll try this and report back. Also the stringing... In forum Hardware, firmware and software help	4 years temu
	X-Axis Suddenly Started Skipping (Replaced bearings, belt ti... In forum Hardware, firmware and software help	4 years temu

Statystyki Forum

559 Fora

62.9 K Tematy

442.9 K Posty

18 Online

67.7 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte