Avisos
Vaciar todo
MintPrint
Grupo: Registrado
Registrado: 2018/10/26
Active Member
1
|
I have figured out the problem, kind of. I have 2 MK3S, and ... En el foro Hardware, firmware and software help |
hace 4 years | |
|
Thank you. There's not super noticeable print artifacts, but... En el foro Hardware, firmware and software help |
hace 4 years | |
|
@martys I removed the belt completely then turned the motor ... En el foro Hardware, firmware and software help |
hace 4 years | |
|
Thank you. I'll try this and report back. Also the stringing... En el foro Hardware, firmware and software help |
hace 4 years | |
|
X-Axis Suddenly Started Skipping (Replaced bearings, belt ti... En el foro Hardware, firmware and software help |
hace 4 years |