Prusa3D Forum

Notifications

Clear all

MintPrint

Skupina: Registrovaný

Přidal se: 2018/10/26

Active Member

	I have figured out the problem, kind of. I have 2 MK3S, and ... In forum Hardware, firmware and software help	před 5 years
	Thank you. There's not super noticeable print artifacts, but... In forum Hardware, firmware and software help	před 5 years
	@martys I removed the belt completely then turned the motor ... In forum Hardware, firmware and software help	před 5 years
	Thank you. I'll try this and report back. Also the stringing... In forum Hardware, firmware and software help	před 5 years
	X-Axis Suddenly Started Skipping (Replaced bearings, belt ti... In forum Hardware, firmware and software help	před 5 years

Fórum Statistiky

585 Fóra

68.1 K Témata

477 K Příspěvky

9 Online

75.7 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed