Prusa3D Forum

Notifiche

Cancella tutti

Mike_GKA

Gruppo: Registrato

Registrato: 2023/02/24

Active Member

	As I only own a Prusa Mini+, I can only answer question 1.Up... Nel forum PrusaSlicer	6 months fa
	Hi rexx555, Every defined virtual extruder has a number. Wi... Nel forum PrusaSlicer	11 months fa
	I have done some improvement to the Tool change G-code ; eli... Nel forum PrusaSlicer	1 year fa
	Thanks @eoyilmaz, but this will not work on Prusa MINI. G-co... Nel forum How do I print this? (Printing help)	1 year fa
	It's an old thread, maybe you have already found a solution.... Nel forum Hardware, firmware and software help	1 year fa
	Thanks @fuchsr I don’t use OctoPrint, everything is printed ... Nel forum How do I print this? (Printing help)	2 years fa
	Thanks @fuchsrwith G4 it works a little better, the message ... Nel forum How do I print this? (Printing help)	2 years fa
	MM Print: How to show display message for next color Nel forum How do I print this? (Printing help)	2 years fa
	I have the same issue and must turn off "wipe tower", with s... Nel forum How do I print this? (Printing help)	2 years fa

Statistiche Forum

559 Forum

63 K Discussioni

443.3 K Post

24 Online

67.9 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso