Prusa3D Forum

Notifications

Clear all

Mike_GKA

Groupe: Enregistré

A(ont) rejoint: 2023/02/24

Active Member

	As I only own a Prusa Mini+, I can only answer question 1.Up... Dans le forum PrusaSlicer	il y a 7 months
	Hi rexx555, Every defined virtual extruder has a number. Wi... Dans le forum PrusaSlicer	il y a 12 months
	I have done some improvement to the Tool change G-code ; eli... Dans le forum PrusaSlicer	il y a 1 year
	Thanks @eoyilmaz, but this will not work on Prusa MINI. G-co... Dans le forum How do I print this? (Printing help)	il y a 1 year
	It's an old thread, maybe you have already found a solution.... Dans le forum Hardware, firmware and software help	il y a 1 year
	Thanks @fuchsr I don’t use OctoPrint, everything is printed ... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Thanks @fuchsrwith G4 it works a little better, the message ... Dans le forum How do I print this? (Printing help)	il y a 2 years
	MM Print: How to show display message for next color Dans le forum How do I print this? (Printing help)	il y a 2 years
	I have the same issue and must turn off "wipe tower", with s... Dans le forum How do I print this? (Printing help)	il y a 2 years

Statistiques du forum

565 Forums

63.5 K Sujets

445.9 K Messages

22 En-ligne

68.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé