English
Forums
Members
Mike B
Activity
 
Notifications
Clear all
Mike B
Mike B
Group: Registered
Joined: 2024/01/25
Estimable Member
4
Profile Activity
Was the "good" part of the print still attached to the bed? ...

In forum Hardware, firmware and software help

 2 years ago
Thanks for the explanations. I am indeed using a MK4, and w...

In forum Hardware, firmware and software help

 2 years ago
That is my obvious course of action - but I'm wondering why ...

In forum Hardware, firmware and software help

 2 years ago
Static discharge resets in the middle of a print

In forum Hardware, firmware and software help

 2 years ago
I printed the glue gun stand in 3D-Printing-Canada White PC+...

In forum How do I print this? (Printing help)

 2 years ago
I was using 3D Printing Canada PETG, it has 10C lower temps ...

In forum How do I print this? (Printing help)

 2 years ago
I was thinking about this some more as I restarted the same ...

In forum How do I print this? (Printing help)

 2 years ago
Printer thinks it finished but partial print

In forum How do I print this? (Printing help)

 2 years ago
I've only been printing for a few weeks (new to both 3D prin...

In forum General discussion, announcements and releases

 2 years ago
As a very new user, my most frustrating experience has been ...

In forum General discussion, announcements and releases

 2 years ago
Almost a year since the original post, I'd like to post a co...

In forum How do I print this? (Printing help)

 2 years ago
Sorry for the noise - I found this thread after doing more s...

In forum General discussion, announcements and releases

 2 years ago
I just started using Prusa Connect yesterday - and I've only...

In forum General discussion, announcements and releases

 2 years ago
Page 7 / 7
Share: