Avisos
Vaciar todo
Michael S
Grupo: Registrado
Registrado: 2020/07/26
Active Member
1
|
Thanks, I will try these suggestions! En el foro How do I print this? (Printing help) |
hace 4 years | |
|
Curling of same corner of prints En el foro How do I print this? (Printing help) |
hace 4 years | |
|
@karl-herbert Thanks for the link. I am assuming you got th... En el foro Hardware, firmware and software help |
hace 4 years | |
|
Technical name for brass olive En el foro Hardware, firmware and software help |
hace 4 years | |
|
Started to print "Spongy" layers En el foro How do I print this? (Printing help) |
hace 4 years | |
|
Thanks @peter-m26 and @bobstro, I was able to zero in calibr... En el foro Hardware, firmware and software help |
hace 4 years | |
|
@nealabrams Do you have a video of the filament curling? En el foro Hardware, firmware and software help |
hace 4 years | |
|
@peter-m26 Thanks Peter, I used Dawn to clean up bed, cold p... En el foro Hardware, firmware and software help |
hace 4 years | |
|
I am having a similar issue but with filaments. I had Z-hei... En el foro Hardware, firmware and software help |
hace 4 years |