Notifications
Clear all
Michael S
Skupina: Registrovaný
Přidal se: 2020/07/26
Active Member
1
|
Thanks, I will try these suggestions! In forum How do I print this? (Printing help) |
před 4 years | |
|
Curling of same corner of prints In forum How do I print this? (Printing help) |
před 4 years | |
|
@karl-herbert Thanks for the link. I am assuming you got th... In forum Hardware, firmware and software help |
před 4 years | |
|
Technical name for brass olive In forum Hardware, firmware and software help |
před 4 years | |
|
Started to print "Spongy" layers In forum How do I print this? (Printing help) |
před 4 years | |
|
Thanks @peter-m26 and @bobstro, I was able to zero in calibr... In forum Hardware, firmware and software help |
před 4 years | |
|
@nealabrams Do you have a video of the filament curling? In forum Hardware, firmware and software help |
před 4 years | |
|
@peter-m26 Thanks Peter, I used Dawn to clean up bed, cold p... In forum Hardware, firmware and software help |
před 4 years | |
|
I am having a similar issue but with filaments. I had Z-hei... In forum Hardware, firmware and software help |
před 4 years |