Prusa3D Forum

Notifications

Clear all

Michael Frost

Grupa: Zarejestrowany

Dołączył: 2020/11/16

New Member

	Perfectly flat. Also, the heatbed is from a different printe... In forum How do I print this? (Printing help)	2 years temu
	First layer prints too high only in the center of the build ... In forum How do I print this? (Printing help)	2 years temu
	There doesn't seem to be any resistance on the leadscrews fo... In forum Hardware, firmware and software help	4 years temu
	Regular Z layer artifacts (3.75mm ish spaced) on my Mk3s In forum Hardware, firmware and software help	4 years temu

Statystyki Forum

566 Fora

63.2 K Tematy

444.2 K Posty

23 Online

68.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte