Prusa3D Forum

Notifications

Clear all

Michael Frost

Skupina: Registrovaný

Přidal se: 2020/11/16

New Member

	Perfectly flat. Also, the heatbed is from a different printe... In forum How do I print this? (Printing help)	před 3 years
	First layer prints too high only in the center of the build ... In forum How do I print this? (Printing help)	před 3 years
	There doesn't seem to be any resistance on the leadscrews fo... In forum Hardware, firmware and software help	před 5 years
	Regular Z layer artifacts (3.75mm ish spaced) on my Mk3s In forum Hardware, firmware and software help	před 5 years

Fórum Statistiky

585 Fóra

68.1 K Témata

477.2 K Příspěvky

10 Online

75.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed