Prusa3D Forum

Notifications

Clear all

mechtheist

Groupe: Enregistré

A(ont) rejoint: 2016/09/11

Active Member

	I got two of these after lots of good prints, wasn't monitor... Dans le forum Others (Archive)	il y a 8 years
	Have you solved it? Noise on Y axis while moving back is ext... Dans le forum Others (Archive)	il y a 8 years
	You need more heat. Heat it up to 300. Tools take a lot of h... Dans le forum Others (Archive)	il y a 8 years
	It's difficult to say that the extra .9 makes a difference, ... Dans le forum Others (Archive)	il y a 8 years
	Nice one. What was the problem with the fan? Regarding that... Dans le forum Others (Archive)	il y a 8 years
	I would say that there are 2 major issues: 1st layer Adhesio... Dans le forum Others (Archive)	il y a 8 years
	I was, just last week, exactly where you are right now tryin... Dans le forum Others (Archive)	il y a 8 years
	Yeah, there really was no need for that! I have a problem g... Dans le forum Others (Archive)	il y a 8 years
	You should submit these to the Facebook group, RepRap Tantru... Dans le forum Others (Archive)	il y a 8 years
	Robert I really would recommend that you use only IPA (or s... Dans le forum Others (Archive)	il y a 8 years
	Robert A couple of things: Is the part fan (the fan at the... Dans le forum Others (Archive)	il y a 8 years
	Breaking the wing and detaching the feet from the bed would ... Dans le forum Others (Archive)	il y a 8 years
	CATastrophic failures printing Adalinda Dans le forum Others (Archive)	il y a 8 years

Statistiques du forum

565 Forums

63.6 K Sujets

446.2 K Messages

25 En-ligne

69 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé