Prusa3D Forum

Notifications

Clear all

mechtheist

Skupina: Registrovaný

Přidal se: 2016/09/11

Active Member

	I got two of these after lots of good prints, wasn't monitor... In forum Others (Archive)	před 8 years
	Have you solved it? Noise on Y axis while moving back is ext... In forum Others (Archive)	před 8 years
	You need more heat. Heat it up to 300. Tools take a lot of h... In forum Others (Archive)	před 8 years
	It's difficult to say that the extra .9 makes a difference, ... In forum Others (Archive)	před 8 years
	Nice one. What was the problem with the fan? Regarding that... In forum Others (Archive)	před 8 years
	I would say that there are 2 major issues: 1st layer Adhesio... In forum Others (Archive)	před 8 years
	I was, just last week, exactly where you are right now tryin... In forum Others (Archive)	před 8 years
	Yeah, there really was no need for that! I have a problem g... In forum Others (Archive)	před 8 years
	You should submit these to the Facebook group, RepRap Tantru... In forum Others (Archive)	před 8 years
	Robert I really would recommend that you use only IPA (or s... In forum Others (Archive)	před 8 years
	Robert A couple of things: Is the part fan (the fan at the... In forum Others (Archive)	před 8 years
	Breaking the wing and detaching the feet from the bed would ... In forum Others (Archive)	před 8 years
	CATastrophic failures printing Adalinda In forum Others (Archive)	před 8 years

Fórum Statistiky

565 Fóra

63.9 K Témata

447.9 K Příspěvky

18 Online

69.6 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed