mavu – Aktivita – Prusa3D Forum

Notifications

Clear all

mavu

Skupina: Registrovaný

Přidal se: 2016/10/17

Estimable Member

	No kisses. Only slic3rs. 🙂 😥 And lower temp... ... In forum Others (Archive)	před 7 years
	Even if the firmware in the printer was garbled, the printer... In forum Others (Archive)	před 7 years
	its just not as "smooth" of an experience as the normal mk2 ... In forum Others (Archive)	před 7 years
	Not yet, but I'm about to embark on that journey. Wish me l... In forum Others (Archive)	před 7 years
	Hey Mohammad, what is the shore hardness of the TPU you are ... In forum Others (Archive)	před 7 years
	There are a couple of limitations from my experience: - can... In forum Others (Archive)	před 7 years
	nice looking box. did you test if the bowden tubes interfe... In forum Others (Archive)	před 7 years
	Some PLAs may be able to work fine retracting at that speed;... In forum Assembly and first prints troubleshooting	před 7 years
	Bill There is, of course another factor involved. With the... In forum Assembly and first prints troubleshooting	před 7 years
	Firmware 3.0.12 Extruder axis steps per unit excluded from M... In forum Others (Archive)	před 7 years
	I just had a try with some FilaFlex (82A shore hardness) fil... In forum Others (Archive)	před 7 years
	For me the "secret" to ABS (and other) printing success was:... In forum Others (Archive)	před 7 years
	When installing the PTFE tube, did you loosen the heat break... In forum Others (Archive)	před 7 years
	I would advise against a continuous tube from spool holder t... In forum Others (Archive)	před 7 years
	Has anyone here managed to get the simple "change color on l... In forum Others (Archive)	před 7 years
	I thought ColourPrint was now included in the latest Slic3r.... In forum Others (Archive)	před 7 years
	Also, one additional question: How do I use the pre-proces... In forum Others (Archive)	před 7 years
	I thought ColourPrint was now included in the latest Slic3r.... In forum Others (Archive)	před 8 years
	Can't get colorprint to work with MM In forum Others (Archive)	před 8 years
	Also, one additional question: How do I use the pre-proces... In forum Others (Archive)	před 8 years

Stránka 3 / 9 Předchozí Další

Fórum Statistiky

565 Fóra

63.8 K Témata

447.3 K Příspěvky

21 Online

69.3 K Uživatelé

Poslední Příspěvek: Will the GPIO Hackerboard be available for the XL ? Nový Uživatel: SilenceDIY Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed