Notifications
Clear all
Matthias U
Matthias U
Skupina: Registrovaný
Přidal se: 2019/12/08
Eminent Member
2
Wenn das so ist, dann verstehe ich nicht so ganz, wieso er n...

In forum Hilfe zur Hardware, Firmware und Software

před 4 years
Ja, auf die Liste bin ich auch schon gestoßen. Nur: welcher ...

In forum Hilfe zur Hardware, Firmware und Software

před 4 years
It does repeat but not at the same position, and Octoprint's...

In forum Hardware, firmware and software help

před 4 years
Temporärer 2-cm-Offset der Y-Achse beim Drucken -- woran kan...

In forum Hilfe zur Hardware, Firmware und Software

před 4 years
Temporary large Y axis offset while printing – any ideas?

In forum Hardware, firmware and software help

před 4 years
… adding an object that's printed with PVA and which acts as...

In forum How do I print this? (Printing help)

před 5 years
Stack multiple objects

In forum How do I print this? (Printing help)

před 5 years
What prevents you to control all stepper motors in the same ...

In forum Improvements (Archive)

před 6 years
@nikolai-r It's more than three wires, each part also gets i...

In forum Improvements (Archive)

před 6 years
@jbash I agree WRT the wires to the print head. High current...

In forum Improvements (Archive)

před 6 years
Filament movement sensor?

In forum Improvements (Archive)

před 6 years
Well, with MMU attached the IR sensor can't do any more move...

In forum Improvements (Archive)

před 6 years
Yes, Octoprint knows about filament changes. It even knows t...

In forum Improvements (Archive)

před 6 years
Getting back to the point, the Pi doesn't have enough I/O li...

In forum Improvements (Archive)

před 6 years
Never mind, stupid "only when needed" option was on.

In forum PrusaSlicer

před 6 years
Large distance between infill and perimeter: ???

In forum PrusaSlicer

před 6 years
Stránka 2 / 2
Share: