Prusa3D Forum

Notifications

Clear all

Matt Kurek

Groupe: Enregistré

A(ont) rejoint: 2018/11/15

Active Member

	3amp Fuse Being Blown No Matter What Motors Are Plugged In /... Dans le forum Hardware, firmware and software help	il y a 3 years
	Should the bearings be packed with grease during assembly? O... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	So what I ended up doing was this: Loosened the grub screw a... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Will check that in a little bit, do you have any other modif... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Stepper Motor Only Turns One Direction Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Stepper Motor Only Turns One Direction Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Either the cable really is too short (support should be able... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Update: I ran the wire for the x-axis motor through the top ... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	X-Axis Motor Cable Too Short / Binding the Z-Aixs at Top?!? Dans le forum Assembly and first prints troubleshooting	il y a 6 years

Statistiques du forum

565 Forums

63.8 K Sujets

447.4 K Messages

23 En-ligne

69.4 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé