Prusa3D Forum

Benachrichtigungen

Alles löschen

Matt Kurek

Gruppe: Registriert

Beigetreten: 2018/11/15

Active Member

	3amp Fuse Being Blown No Matter What Motors Are Plugged In /... Im Forum Hardware, firmware and software help	Vor 3 years
	Should the bearings be packed with grease during assembly? O... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	So what I ended up doing was this: Loosened the grub screw a... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Will check that in a little bit, do you have any other modif... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Stepper Motor Only Turns One Direction Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Stepper Motor Only Turns One Direction Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Either the cable really is too short (support should be able... Im Forum Assembly and first prints troubleshooting	Vor 6 years
	Update: I ran the wire for the x-axis motor through the top ... Im Forum Assembly and first prints troubleshooting	Vor 6 years
	X-Axis Motor Cable Too Short / Binding the Z-Aixs at Top?!? Im Forum Assembly and first prints troubleshooting	Vor 6 years

Forums-Statistiken

565 Foren

63.8 K Themen

447.4 K Beiträge

23 Online

69.4 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen