Prusa3D Forum

Notifications

Clear all

Matt Kurek

Group: Registered

Joined: 2018/11/15

Active Member

	3amp Fuse Being Blown No Matter What Motors Are Plugged In /... In forum Hardware, firmware and software help	3 years ago
	Should the bearings be packed with grease during assembly? O... In forum Assembly and first prints troubleshooting	5 years ago
	So what I ended up doing was this: Loosened the grub screw a... In forum Assembly and first prints troubleshooting	5 years ago
	Will check that in a little bit, do you have any other modif... In forum Assembly and first prints troubleshooting	5 years ago
	Stepper Motor Only Turns One Direction In forum Assembly and first prints troubleshooting	5 years ago
	Stepper Motor Only Turns One Direction In forum Assembly and first prints troubleshooting	5 years ago
	Either the cable really is too short (support should be able... In forum Assembly and first prints troubleshooting	6 years ago
	Update: I ran the wire for the x-axis motor through the top ... In forum Assembly and first prints troubleshooting	6 years ago
	X-Axis Motor Cable Too Short / Binding the Z-Aixs at Top?!? In forum Assembly and first prints troubleshooting	6 years ago

Forum Statistics

579 Forums

65.4 K Topics

457.5 K Posts

26 Online

72.5 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed