|
Help printing Taulman Alloy 910 nylon (print "tapers&qu... In forum How do I print this? (Printing help) |
6 years ago |
|
This explains what happened to me. Not long after upgrading ... In forum General discussion, announcements and releases |
7 years ago |
|
Cold end fan (30mm) kinda not working In forum Others (Archive) |
8 years ago |
|
Are you sure that the auto bed level feature is working for ... In forum Others (Archive) |
9 years ago |
|
I'm a bit confused.
I tried multiple times to go to 3.0.5 R... In forum Others (Archive) |
9 years ago |
|
I'd say the hotend is too small to be correctly measured wit... In forum Others (Archive) |
9 years ago |
|
Rambo board / stepper temps? In forum Others (Archive) |
9 years ago |
|
I found one problem, not sure if it's just me but, when I pr... In forum Others (Archive) |
9 years ago |
|
Seems pretty fine! My X/Y calibration was perpendicular!
The... In forum Others (Archive) |
9 years ago |
|
Check this post,
I think your bed is a bit twisted and nee... In forum Others (Archive) |
9 years ago |
|
I do 105c first layer and 110c from layer two. No fan. Wipe ... In forum Others (Archive) |
9 years ago |
|
I get the same marks on my prints, and they're more apparent... In forum Others (Archive) |
9 years ago |
|
Martin
There is a problem calibrating cold - the bed is not... In forum Others (Archive) |
9 years ago |
|
Hi. I also noticed I have this issue - the two screws in the... In forum Others (Archive) |
9 years ago |
|
I have that too but it's not causing any issues. I stopped c... In forum Others (Archive) |
9 years ago |
|
The extruder holder push the X-endstop with a small part. In... In forum Others (Archive) |
9 years ago |
|
Hi there!
I am a new user and wanted to say hello to everyon... In forum Others (Archive) |
9 years ago |
|
Kevin
Your file start GCode:
M107
M190 S83 ; set bed tempe... In forum Others (Archive) |
9 years ago |
|
Do i need to be using a G29 command at all? I've seen menti... In forum Others (Archive) |
9 years ago |
|
Great suggestion - here is a link to the gcode as i couldn't... In forum Others (Archive) |
9 years ago |
