Prusa3D Forum

Notifications

Clear all

MartinV

Groupe: Enregistré

A(ont) rejoint: 2020/04/11

Active Member

	I'm also interested in reducing stringing and was looking at... Dans le forum PrusaSlicer	il y a 1 year
	Preset confusion Dans le forum PrusaSlicer	il y a 1 year
	Getting inside and outside print dimensions accurate Dans le forum PrusaSlicer	il y a 2 years
	I believe you're not seeing the issue with the raft because ... Dans le forum PrusaSlicer	il y a 2 years
	Thanks for the reply. I had wondered about changing the min... Dans le forum PrusaSlicer	il y a 2 years
	Support material interface, inter-layer spacing. Where can I... Dans le forum PrusaSlicer	il y a 2 years
	PHA prints warping and failing Dans le forum How do I print this? (Printing help)	il y a 2 years
	This model was a specific example of a more general issue an... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I had a similar issue, and resolved it by adding a surplus h... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Supports on vertical surfaces don't have any effect Dans le forum How do I print this? (Printing help)	il y a 2 years
	@guy-k2 Going by the pictures, those boost circuits have the... Dans le forum Coronavirus (COVID-19)	il y a 5 years
	I know you replied to Guy, but as I had the same idea as you... Dans le forum Coronavirus (COVID-19)	il y a 5 years
	Hi Guy, I have been trying to send you a private message sin... Dans le forum Coronavirus (COVID-19)	il y a 5 years

Statistiques du forum

585 Forums

68.2 K Sujets

478 K Messages

9 En-ligne

76 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé