Prusa3D Forum

Notifications

Clear all

Martin

Groupe: Enregistré

A(ont) rejoint: 2017/12/20

Active Member

	I've been having the same issue without a resolution yet. I ... Dans le forum Hardware, firmware and software help	il y a 7 years
	Have you tried then lowering the front left side? If you rea... Dans le forum Hardware, firmware and software help	il y a 7 years
	I think that the OctoPrint plugin screenshot is where I’d st... Dans le forum Hardware, firmware and software help	il y a 7 years
	inconsistent first layer, print bed warp. Dans le forum Hardware, firmware and software help	il y a 7 years
	I've only experienced this once a long time ago on my MK2 wh... Dans le forum How do I print this? (Printing help)	il y a 7 years
	Also check that the x axis rods are smooth and lubricated. I... Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	Overextruding and/or too low a z-height can lead to 2nd laye... Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	odd layer issue Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	confused Dans le forum How do I print this? (Printing help)	il y a 7 years
	I got in touch with Prusa support and they are going to repl... Dans le forum Others (Archive)	il y a 8 years
	Well I think I found the issue. I was making sure the rods w... Dans le forum Others (Archive)	il y a 8 years
	Hi Martin, if twoI would look for obstructions to the move... Dans le forum Others (Archive)	il y a 8 years
	It may also be worth noting that this was the first time I u... Dans le forum Others (Archive)	il y a 8 years
	Strange calibration issue Dans le forum Others (Archive)	il y a 8 years

Statistiques du forum

585 Forums

68.2 K Sujets

477.4 K Messages

14 En-ligne

75.9 K Membres

Le dernier des messages: Forum prefers to speak Czech to me Notre nouveau membre: mnentwig Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé