|
I've been having the same issue without a resolution yet. I ... In forum Hardware, firmware and software help |
6 years ago |
|
Have you tried then lowering the front left side? If you rea... In forum Hardware, firmware and software help |
7 years ago |
|
I think that the OctoPrint plugin screenshot is where I’d st... In forum Hardware, firmware and software help |
7 years ago |
|
inconsistent first layer, print bed warp. In forum Hardware, firmware and software help |
7 years ago |
|
I've only experienced this once a long time ago on my MK2 wh... In forum How do I print this? (Printing help) |
7 years ago |
|
Also check that the x axis rods are smooth and lubricated. I... In forum Assembly and first prints troubleshooting |
7 years ago |
|
Overextruding and/or too low a z-height can lead to 2nd laye... In forum Assembly and first prints troubleshooting |
7 years ago |
|
odd layer issue In forum Assembly and first prints troubleshooting |
7 years ago |
|
confused In forum How do I print this? (Printing help) |
7 years ago |
|
I got in touch with Prusa support and they are going to repl... In forum Others (Archive) |
7 years ago |
|
Well I think I found the issue. I was making sure the rods w... In forum Others (Archive) |
7 years ago |
|
Hi Martin,
if twoI would look for obstructions to the move... In forum Others (Archive) |
7 years ago |
|
It may also be worth noting that this was the first time I u... In forum Others (Archive) |
7 years ago |
|
Strange calibration issue In forum Others (Archive) |
7 years ago |
