Prusa3D Forum

Notifiche

Cancella tutti

Martin

Gruppo: Registrato

Registrato: 2017/12/20

Active Member

	I've been having the same issue without a resolution yet. I ... Nel forum Hardware, firmware and software help	7 years fa
	Have you tried then lowering the front left side? If you rea... Nel forum Hardware, firmware and software help	7 years fa
	I think that the OctoPrint plugin screenshot is where I’d st... Nel forum Hardware, firmware and software help	7 years fa
	inconsistent first layer, print bed warp. Nel forum Hardware, firmware and software help	7 years fa
	I've only experienced this once a long time ago on my MK2 wh... Nel forum How do I print this? (Printing help)	7 years fa
	Also check that the x axis rods are smooth and lubricated. I... Nel forum Assembly and first prints troubleshooting	7 years fa
	Overextruding and/or too low a z-height can lead to 2nd laye... Nel forum Assembly and first prints troubleshooting	7 years fa
	odd layer issue Nel forum Assembly and first prints troubleshooting	7 years fa
	confused Nel forum How do I print this? (Printing help)	7 years fa
	I got in touch with Prusa support and they are going to repl... Nel forum Others (Archive)	8 years fa
	Well I think I found the issue. I was making sure the rods w... Nel forum Others (Archive)	8 years fa
	Hi Martin, if twoI would look for obstructions to the move... Nel forum Others (Archive)	8 years fa
	It may also be worth noting that this was the first time I u... Nel forum Others (Archive)	8 years fa
	Strange calibration issue Nel forum Others (Archive)	8 years fa

Statistiche Forum

585 Forum

68.2 K Discussioni

477.8 K Post

11 Online

75.9 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso