Prusa3D Forum

Avisos

Vaciar todo

Martin

Grupo: Registrado

Registrado: 2017/12/20

Active Member

	I've been having the same issue without a resolution yet. I ... En el foro Hardware, firmware and software help	hace 7 years
	Have you tried then lowering the front left side? If you rea... En el foro Hardware, firmware and software help	hace 7 years
	I think that the OctoPrint plugin screenshot is where I’d st... En el foro Hardware, firmware and software help	hace 7 years
	inconsistent first layer, print bed warp. En el foro Hardware, firmware and software help	hace 7 years
	I've only experienced this once a long time ago on my MK2 wh... En el foro How do I print this? (Printing help)	hace 7 years
	Also check that the x axis rods are smooth and lubricated. I... En el foro Assembly and first prints troubleshooting	hace 7 years
	Overextruding and/or too low a z-height can lead to 2nd laye... En el foro Assembly and first prints troubleshooting	hace 7 years
	odd layer issue En el foro Assembly and first prints troubleshooting	hace 7 years
	confused En el foro How do I print this? (Printing help)	hace 7 years
	I got in touch with Prusa support and they are going to repl... En el foro Others (Archive)	hace 8 years
	Well I think I found the issue. I was making sure the rods w... En el foro Others (Archive)	hace 8 years
	Hi Martin, if twoI would look for obstructions to the move... En el foro Others (Archive)	hace 8 years
	It may also be worth noting that this was the first time I u... En el foro Others (Archive)	hace 8 years
	Strange calibration issue En el foro Others (Archive)	hace 8 years

Estadísticas del Foro

585 Foros

68.2 K Temas

477.5 K Respuestas

15 En línea

75.9 K Miembros

Iconos del foro: El foro no contiene publicaciones sin leer El foro contiene publicaciones sin leer

Iconos de los Temas: No respondidos Respondido Activo Popular Fijo No aprobados Resuelto Privado Cerrado