Prusa3D Forum

Notifications

Clear all

Martin

Group: Registered

Joined: 2017/12/20

Active Member

	I've been having the same issue without a resolution yet. I ... In forum Hardware, firmware and software help	6 years ago
	Have you tried then lowering the front left side? If you rea... In forum Hardware, firmware and software help	7 years ago
	I think that the OctoPrint plugin screenshot is where I’d st... In forum Hardware, firmware and software help	7 years ago
	inconsistent first layer, print bed warp. In forum Hardware, firmware and software help	7 years ago
	I've only experienced this once a long time ago on my MK2 wh... In forum How do I print this? (Printing help)	7 years ago
	Also check that the x axis rods are smooth and lubricated. I... In forum Assembly and first prints troubleshooting	7 years ago
	Overextruding and/or too low a z-height can lead to 2nd laye... In forum Assembly and first prints troubleshooting	7 years ago
	odd layer issue In forum Assembly and first prints troubleshooting	7 years ago
	confused In forum How do I print this? (Printing help)	7 years ago
	I got in touch with Prusa support and they are going to repl... In forum Others (Archive)	7 years ago
	Well I think I found the issue. I was making sure the rods w... In forum Others (Archive)	7 years ago
	Hi Martin, if twoI would look for obstructions to the move... In forum Others (Archive)	7 years ago
	It may also be worth noting that this was the first time I u... In forum Others (Archive)	7 years ago
	Strange calibration issue In forum Others (Archive)	7 years ago

Forum Statistics

565 Forums

64.3 K Topics

450 K Posts

21 Online

70.5 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed