|
checking the ten or so failed prints in my wastebasket - nop... Dans le forum Input Shaper (MK4) |
il y a 5 months |
|
Layer shifts, see. Doesn't seem to be limited to PETG, but s... Dans le forum Input Shaper (MK4) |
il y a 5 months |
|
Still observed with Slicer 2.8. In 2.7.4, I had repeated lay... Dans le forum Input Shaper (MK4) |
il y a 5 months |
|
Just completed the printer upgrade (including MMU). Printed ... Dans le forum Hardware, firmware and software help |
il y a 6 months |
|
Two years later, and it still happens to me. Specifically,wh... Dans le forum Hardware, firmware and software help |
il y a 7 months |
|
Yippiee! Yes, that's it - even now in December 2022, this is... Dans le forum How do I print this? (Printing help) |
il y a 2 years |
|
Thanks - yes, that sort of works in this case. "Sort of" bec... Dans le forum Hardware, firmware and software help |
il y a 3 years |
|
Slicer creates soluble layer on top (and supports to carry i... Dans le forum Hardware, firmware and software help |
il y a 3 years |
|
@lichtjaeger Bingo! Works like a charm - thanks. Dans le forum How do I print this? (Printing help) |
il y a 3 years |
|
Create multipart MMU print file from F3D Dans le forum How do I print this? (Printing help) |
il y a 3 years |
|
Could be a bit far fetched, but your experience might be rel... Dans le forum General discussion, announcements and releases |
il y a 4 years |
