|
checking the ten or so failed prints in my wastebasket - nop... En el foro Input Shaper (MK4) |
hace 8 months |
|
Layer shifts, see. Doesn't seem to be limited to PETG, but s... En el foro Input Shaper (MK4) |
hace 8 months |
|
Still observed with Slicer 2.8. In 2.7.4, I had repeated lay... En el foro Input Shaper (MK4) |
hace 8 months |
|
Just completed the printer upgrade (including MMU). Printed ... En el foro Hardware, firmware and software help |
hace 9 months |
|
Two years later, and it still happens to me. Specifically,wh... En el foro Hardware, firmware and software help |
hace 10 months |
|
Yippiee! Yes, that's it - even now in December 2022, this is... En el foro How do I print this? (Printing help) |
hace 2 years |
|
Thanks - yes, that sort of works in this case. "Sort of" bec... En el foro Hardware, firmware and software help |
hace 4 years |
|
Slicer creates soluble layer on top (and supports to carry i... En el foro Hardware, firmware and software help |
hace 4 years |
|
@lichtjaeger Bingo! Works like a charm - thanks. En el foro How do I print this? (Printing help) |
hace 4 years |
|
Create multipart MMU print file from F3D En el foro How do I print this? (Printing help) |
hace 4 years |
|
Could be a bit far fetched, but your experience might be rel... En el foro General discussion, announcements and releases |
hace 4 years |
