|
checking the ten or so failed prints in my wastebasket - nop... In forum Input Shaper (MK4) |
5 months ago |
|
Layer shifts, see. Doesn't seem to be limited to PETG, but s... In forum Input Shaper (MK4) |
5 months ago |
|
Still observed with Slicer 2.8. In 2.7.4, I had repeated lay... In forum Input Shaper (MK4) |
5 months ago |
|
Just completed the printer upgrade (including MMU). Printed ... In forum Hardware, firmware and software help |
6 months ago |
|
Two years later, and it still happens to me. Specifically,wh... In forum Hardware, firmware and software help |
7 months ago |
|
Yippiee! Yes, that's it - even now in December 2022, this is... In forum How do I print this? (Printing help) |
2 years ago |
|
Thanks - yes, that sort of works in this case. "Sort of" bec... In forum Hardware, firmware and software help |
3 years ago |
|
Slicer creates soluble layer on top (and supports to carry i... In forum Hardware, firmware and software help |
3 years ago |
|
@lichtjaeger Bingo! Works like a charm - thanks. In forum How do I print this? (Printing help) |
3 years ago |
|
Create multipart MMU print file from F3D In forum How do I print this? (Printing help) |
3 years ago |
|
Could be a bit far fetched, but your experience might be rel... In forum General discussion, announcements and releases |
4 years ago |