Avisos
Vaciar todo
Mario M
Grupo: Registrado
Registrado: 2021/07/25
Active Member
1
|
I tightened the idler screws by 1/4 turn and was able to unl... En el foro Hardware, firmware and software help |
hace 2 weeks | |
|
Addition Although the filament can't be retracted, it can be... En el foro Hardware, firmware and software help |
hace 2 weeks | |
|
Core One does not unload fillament En el foro Hardware, firmware and software help |
hace 2 weeks | |
|
Same here. Flashing the Firmware from 4.3.1 to 4.3.4 solved ... En el foro Hardware, firmware and software help |
hace 4 years | |
|
Adjusting the PINDA height did the trick. Thanks. En el foro Hardware, firmware and software help |
hace 4 years | |
|
Adjust nozzle Z, bed to low? En el foro Hardware, firmware and software help |
hace 4 years |