Notifications
Clear all
Mario M
Skupina: Registrovaný
Přidal se: 2021/07/25
Active Member
1
|
I tightened the idler screws by 1/4 turn and was able to unl... In forum Hardware, firmware and software help |
před 2 months | |
|
Addition Although the filament can't be retracted, it can be... In forum Hardware, firmware and software help |
před 3 months | |
|
Core One does not unload fillament In forum Hardware, firmware and software help |
před 3 months | |
|
Same here. Flashing the Firmware from 4.3.1 to 4.3.4 solved ... In forum Hardware, firmware and software help |
před 4 years | |
|
Adjusting the PINDA height did the trick. Thanks. In forum Hardware, firmware and software help |
před 4 years | |
|
Adjust nozzle Z, bed to low? In forum Hardware, firmware and software help |
před 4 years |