Notifications
Clear all
Macmagoo
Macmagoo
Groupe: Enregistré
A(ont) rejoint: 2021/01/02
Active Member
1
IS prints have a poor top surface

Dans le forum Input Shaper XL (Multi-Tool)

il y a 2 weeks
I have sorted it I used the wrong screws on the upper magnet...

Dans le forum Hardware, firmware and software help

il y a 2 months
The magnets hold a metal object just fine. The unmounted mag...

Dans le forum Hardware, firmware and software help

il y a 2 months
RE: XL5T Enclosure Magnets

Dans le forum Hardware, firmware and software help

il y a 2 months
I will take some photos of my upper magnet setup. I am absol...

Dans le forum Hardware, firmware and software help

il y a 2 months
XL5T Enclosure Magnets

Dans le forum Hardware, firmware and software help

il y a 2 months
The filament sensor with PETG going through it is driving me...

Dans le forum General discussion, announcements and releases

il y a 2 months
It is not an early XL and it is definitely 0.4 nozzles.

Dans le forum How do I print this? (Printing help)

il y a 3 months
I am using a 0.4 nozzle.

Dans le forum How do I print this? (Printing help)

il y a 3 months
Pressure Advance or under extrusion

Dans le forum How do I print this? (Printing help)

il y a 3 months
I ordered on 1st July 2022 every time I check the shipping t...

Dans le forum General discussion, announcements and releases

il y a 2 years
MK3S+ Filament sensor cover

Dans le forum Assembly and first prints troubleshooting

il y a 4 years
@karl-herbert Thanks I will try that tomorrow.

Dans le forum Assembly and first prints troubleshooting

il y a 4 years
Y Belt Idler issue

Dans le forum Assembly and first prints troubleshooting

il y a 4 years
Partager :