Notifications
Clear all
MackDan
Groupe: Enregistré
A(ont) rejoint: 2022/12/12
Active Member
1
|
Instead of trying to open a .stl file I tried to repair a ra... Dans le forum PrusaSlicer |
il y a 3 years | |
|
I can't even click on a file to try and load it. Once I clic... Dans le forum PrusaSlicer |
il y a 3 years | |
|
PrusaSlicer locks up trying to load a .stl Dans le forum PrusaSlicer |
il y a 3 years | |
|
I think I figured it out. Not PrusaSlicers fault, just IDEX ... Dans le forum PrusaSlicer |
il y a 3 years | |
|
I'm not having problems with the Extruders. They [0], and [1... Dans le forum PrusaSlicer |
il y a 3 years | |
|
Bed temp goes to zero at layer 2 Dans le forum PrusaSlicer |
il y a 3 years |